- 1. Taper question (score: 1)
- Author: "Larry McAfee" <lgmcafee@mchsi.com>
- Date: Mon, 29 May 2006 18:02:12 -0500
- What Don Thigpen told you to do is the correct way to cut a taper without a taper attachment. But if this taper doesn't need to be that close you can set your compound and cut a taper as far as your
- /html/land-speed/2006-05/msg00363.html (6,951 bytes)
- 2. Re: Taper question (score: 1)
- Author: "don thigpen" <piggy@accessatc.net>
- Date: Mon, 29 May 2006 19:16:13 -0400
- you can also step turn it and use a rough bastard file to blend the steps . CAUTION when using a file make sure it has a handle and make sure you do NOT stand with your body behind the file , stand t
- /html/land-speed/2006-05/msg00365.html (6,981 bytes)
- 3. Re: Taper question (score: 1)
- Author: "Rich Fox" <v4gr@rcn.com>
- Date: Mon, 29 May 2006 16:17:34 -0700
- What's the big deal. I cut tapers all the time. What I want to know is how do you cut a straight diameter? RF -- Original Message -- From: "Larry McAfee" <lgmcafee@mchsi.com> To: "land speed" <land-s
- /html/land-speed/2006-05/msg00366.html (7,361 bytes)
- 4. Re: Taper question (score: 1)
- Author: "don thigpen" <piggy@accessatc.net>
- Date: Mon, 29 May 2006 19:30:08 -0400
- well rich i can tell ya how but then i may have to kill ya lol , actually that is probably harder to do than a taper , it takes a good machine well set up and attention to detail . i find that the ea
- /html/land-speed/2006-05/msg00367.html (6,868 bytes)
- 5. Taper question (score: 1)
- Author: "Larry McAfee" <lgmcafee@mchsi.com>
- Date: Mon, 29 May 2006 21:41:15 -0500
- here ya go kt http://www.technologystudent.com/equip1/mlathe3.htm That shows a good picture but they left out how your going to turn the piece on just a center. You need to put a lathe dog on the pie
- /html/land-speed/2006-05/msg00372.html (6,804 bytes)
This search system is powered by
Namazu