John. It will look like a bar that is running out a lot. The cut will start on the high side and work it's way around until it's round. Only the center of the bar, and it's diameter will change. It's
So Dahlgren sent me this little lathe down here... and I'm trying to sort out how I'd make a taper on a 1" piece of bar stock that is supposed to end up looking like a shifter handle... picture a 1/2
well kt , if ya dont have a taper attachment then you have to set the tailstock over and mount the part between centers , you can make a center to go in the chuck from a scrap of round stock and you