- 1. Torque on prop & drive shaft bolts (TR6) (score: 1)
- Author: Unknown
- Date: Thu, 4 Sep 97 9:28:48 -0400
- Hey all, The assembly phase is proceeding nicely. I was tighting the bolts for the rear-hubs last night and I could determine what to torque them to. The Bently manual says 90-120 lbs! Nevermind that
- /html/triumphs/1997-09/msg00250.html (7,254 bytes)
- 2. Re: Torque on prop & drive shaft bolts (TR6) (score: 1)
- Author: Unknown
- Date: Thu, 04 Sep 1997 11:06:44 -0400
- That's right. Using a fully-threaded bolt will tend to round out the holes in the yoke over time, due both to the fact that it doesn't fit quite so tight, and also since the threads are pretty sharp.
- /html/triumphs/1997-09/msg00260.html (7,835 bytes)
This search system is powered by
Namazu