Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Trans\s+advice\s+needed\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Trans\s+advice\s+needed\s*$/: 6 ]

Total 6 documents matching your query.

1. Trans advice needed (score: 1): Author: "Jack W. Drews" <vinttr4@forbin.com>; Date: Fri, 05 Jun 1998 07:57:22 -0500; We rebuilt our TR gearbox, putting in new bushings, setting endplay per specs, and replacing synchro rings. After about four hours racing time, the synchros on third and fourth don't synchro very muc; /html/fot/1998-06/msg00036.html (7,220 bytes)
2. RE: Trans advice needed (score: 1): Author: Chip Bond <spirals@esinet.net>; Date: Fri, 5 Jun 1998 11:04:44 -0400; Uncle Jack, the word going around is that it's better to use decent old synchros than the repro stuff. Evidently, the new ones don't last very long in even street car use. I'm using redline MTL (75/8; /html/fot/1998-06/msg00042.html (7,932 bytes)
3. Re: Trans advice needed (score: 1): Author: "Irv Korey" <emanteno@ix.netcom.com>; Date: Fri, 5 Jun 1998 16:01:17 -0500; long When I re-did the gearbox for my 4, I ordered new syncros from TRF. They were so thin and flimsy compared to the old ones that I chose to re-use the old ones. Irv; /html/fot/1998-06/msg00046.html (7,076 bytes)
4. Re: Trans advice needed (score: 1): Author: Ted Schumacher <tedtsimx@mail.bright.net>; Date: Sat, 06 Jun 1998 08:17:17 -0400; fot list. re the synchros. old synchros (original) can easily be made "new" by laying them on a surface mill and thinning the flat side a few thousandth of an inch. this causes the syncro ring to go; /html/fot/1998-06/msg00049.html (7,832 bytes)
5. Re: Trans advice needed (score: 1): Author: "Bob Kramer" <rgk@flash.net>; Date: Sat, 6 Jun 1998 11:18:52 -0600; Hey Ted, In the same vein. I have a lot of TR 3rd/4th gear bushes that are worn lengthwise but OK otherwise. My thought is that 2 can make one if I cut the each almost in half tossing the short sides; /html/fot/1998-06/msg00054.html (7,348 bytes)
6. Re: Trans advice needed (score: 1): Author: Catpusher@aol.com; Date: Mon, 8 Jun 1998 23:03:07 EDT; << > Irv fot list. re the synchros. old synchros (original) can easily be made "new" by laying them on a surface mill and thinning the flat side a few thousandth of an inch. this causes the syncro ri; /html/fot/1998-06/msg00074.html (7,748 bytes)

Current List: 1 - 6
Page: [1]