- 1. U-Joints (score: 1)
- Author: "DrMayf" <drmayf@teknett.com>
- Date: Thu, 12 May 2005 16:05:02 -0700
- Is there one among the group who is a bona fide expert on u-joints? I had a drive shaft made quite eome time ago because I needed it for spacing, dimensions etc. I thought stock u-joints were used. W
- /html/land-speed/2005-05/msg00166.html (7,062 bytes)
- 2. RE: U-Joints (score: 1)
- Author: "Albaugh, Neil" <albaugh_neil@ti.com>
- Date: Thu, 12 May 2005 19:24:35 -0500
- Sorry I can't help you, Mayf-- all my u- joints are Rzeppa types. Regards, Neil Tucson, AZ Is there one among the group who is a bona fide expert on u-joints? I had a drive shaft made quite eome time
- /html/land-speed/2005-05/msg00168.html (7,527 bytes)
- 3. Re: U-Joints (score: 1)
- Author: salt <saltracer@shaw.ca>
- Date: Thu, 12 May 2005 17:55:14 -0700
- I'm not bona fide but sounds like a 1330. If it has the internal snap rings it would probably be a 3R. Just measure up your yoke and get a cross-over joint of the two sizes. Not the best method but i
- /html/land-speed/2005-05/msg00169.html (8,062 bytes)
This search system is powered by
Namazu