- 1. Water pump hub sizes (score: 1)
- Author: "Kathy and Erich Coiner" <kathy.coiner@gte.net>
- Date: Sat, 20 Apr 2002 18:44:45 -0700
- Hello list. I picked up a C9DZ-A fan for my tiger. I need to open the center hole up from 5/8 inch. I measured diameter of the hole in the water pump pulley. It was 1.002 inches. I measured the pilot
- /html/tigers/2002-04/msg00200.html (7,211 bytes)
- 2. Re: Water pump hub sizes (score: 1)
- Author: DJoh797014@aol.com
- Date: Sat, 20 Apr 2002 23:21:34 EDT
- Look someplace else for your runout problem Remember these are ordinary production engines. The water pump shaft is about 1 inch + or - and the pulley hub hole is 1 inch + or -. As long as the hub f
- /html/tigers/2002-04/msg00203.html (7,378 bytes)
- 3. Re: Water pump hub sizes (score: 1)
- Author: Steve Laifman <SLaifman@SoCal.rr.com>
- Date: Sat, 20 Apr 2002 22:38:41 -0700
- My Rolex (fine Swiss watch, no?) Doesn't keep time as well as my older Seiko quartz. The old technology, at it's finest tolerances, can't beat the modern version at production tolerances. So just ge
- /html/tigers/2002-04/msg00204.html (7,131 bytes)
- 4. Re: Water pump hub sizes (score: 1)
- Author: "Kathy and Erich Coiner" <kathy.coiner@gte.net>
- Date: Sun, 21 Apr 2002 16:40:51 -0700
- See below -- Original Message -- From: <DJoh797014@aol.com> To: <kathy.coiner@gte.net> Cc: <tigers@autox.team.net> Sent: Saturday, April 20, 2002 8:21 PM Subject: Re: Water pump hub sizes Not necessa
- /html/tigers/2002-04/msg00208.html (8,408 bytes)
- 5. Re: Water pump hub sizes (score: 1)
- Author: Theo Smit <tsmit@shaw.ca>
- Date: Sun, 21 Apr 2002 19:53:43 -0600
- Isn't it true that the large projection on the pump is an unmachined cast surface, and therefore subject to whatever casting inaccuracies Ford specs into their products? Remember that the Tiger water
- /html/tigers/2002-04/msg00211.html (9,141 bytes)
This search system is powered by
Namazu