Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*broken\s+cable\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*broken\s+cable\s*$/: 10 ]

Total 10 documents matching your query.

1. broken cable (score: 1): Author: Unknown; Date: Tue, 20 May 2003 19:16:41 EDT; Sorry for the cross listing. Can anyone share info on the cure for a broken engine compartment - hood release cable. cheers, Ike Levine 1974 TR6 /// triumphs@autox.team.net mailing list /// or try ht; /html/triumphs/2003-05/msg00636.html (7,009 bytes)
2. RE: broken cable (score: 1): Author: Unknown; Date: Tue, 20 May 2003 17:00:23 -0700 FILETIME=[F9FE1920:01C31F2B]; Check out www.buckeyetriumphs.org/technical/Bonnet/Bonnet.htm Randall /// triumphs@autox.team.net mailing list /// or try http://www.team.net/cgi-bin/majorcool /// Archives at http://www.team.net/ar; /html/triumphs/2003-05/msg00639.html (7,080 bytes)
3. Re: broken cable (score: 1): Author: Unknown; Date: Tue, 20 May 2003 20:25:47 -0400; The VTR site has a good article here http://www.vtr.org/maintain/stuck-bonnet.html Bob Danielson 1975 TR6 Status at http://pages.cthome.net/BobD /// triumphs@autox.team.net mailing list /// or try ht; /html/triumphs/2003-05/msg00640.html (7,797 bytes)
4. Re: broken cable (score: 1): Author: Unknown; Date: Wed, 21 May 2003 01:44:27 +0100; There's a hole under the dash that (at least on RHD models) comes out below and to one side of the catch. Armed with a metal bar with a 90 degree bend in it, it is allegedly possible to spring the c; /html/triumphs/2003-05/msg00641.html (8,073 bytes)
5. Re: broken cable (score: 1): Author: Unknown; Date: Tue, 20 May 2003 22:42:25 -0700; When you do get it open, don't forget to install a second short cable direct from the passenger side wheel well, tucked well up out of sight. Then you won't have that problem again. Best wishes. Bill; /html/triumphs/2003-05/msg00653.html (7,842 bytes)
6. re: broken cable (score: 1): Author: Unknown; Date: Wed, 21 May 2003 07:52:31 EDT; Just install a new cable - these get quite a bit of action - I have never replaced mine but have oiled it periodically and don't allow kinks - it's finally getting frayed and ready to go after 29 yea; /html/triumphs/2003-05/msg00654.html (7,214 bytes)
7. broken cable (score: 1): Author: Unknown; Date: Wed, 21 May 2003 08:41:18 -0400; Message text written by INTERNET:IkeLevine@aol.com release cable. cheers, Ike Levine 1974 TR6 < You mean like "how do I get my hood open?" There was a factory bulletin on opening the bonnet after the; /html/triumphs/2003-05/msg00656.html (8,145 bytes)
8. broken cable (score: 1): Author: Unknown; Date: Wed, 21 May 2003 10:34:44 -0400 +SPRs MIAS5EXFG4, MIAS5AUFPV and DHAG4Y6R7W, MATTEST |November 8th, 2002) at 05/21/2003 10:37:14 AM; You've gotten lots of responses on how to get past this problem. To ensure you never have to go through this again, see: http://www.btinternet.com/~dmsims/hood_release.htm Dennis Culligan / 1976 TR6; /html/triumphs/2003-05/msg00659.html (7,546 bytes)
9. Re: broken cable (score: 1): Author: Unknown; Date: Wed, 21 May 2003 10:42:29 EDT; you're lucky - to have old ones - the new ones are crap - i've had the outer cable seperate from its holder and slid thru (on the end inside the car) on about 6 in the last 2 years Cheers Jack Mc ///; /html/triumphs/2003-05/msg00660.html (7,497 bytes)
10. Re: broken cable (score: 1): Author: Unknown; Date: Wed, 21 May 2003 21:30:04 EDT; Moss sells an emergency cable so you will have a backup. The alternative, when your only cable breaks, and they ALL do (personal experience talking!) is laying up under the car with a long screwdrive; /html/triumphs/2003-05/msg00697.html (7,250 bytes)

Current List: 1 - 10
Page: [1]