Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*clutch\s+hydraulics\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*clutch\s+hydraulics\s*$/: 6 ]

Total 6 documents matching your query.

1. Clutch Hydraulics (score: 1): Author: "Ree Gurley" <reegurley@mindspring.com>; Date: Wed, 17 Jan 2001 12:53:34 -0600; I rebuilt my slave and master cylinders yesterday, re-installed them, & bled the system (conventionally & with MityVac). I did not operationally test the clutch then (getting too cold and dark). Trie; /html/spitfires/2001-01/msg00408.html (7,603 bytes)
2. Re: Clutch Hydraulics (score: 1): Author: "Jeff McNeal" <jmcneal@ohms.com>; Date: Wed, 17 Jan 2001 10:23:36 -0800; I think I read somewhere that if your slave cylinder isn't fully retracted before bleeding the clutch, you can run into this very problem. Remove the slave cylinder, depress the plunger all the way b; /html/spitfires/2001-01/msg00409.html (9,132 bytes)
3. Re: Clutch Hydraulics (score: 1): Author: "Jeff McNeal" <jmcneal@ohms.com>; Date: Wed, 17 Jan 2001 10:26:33 -0800; Ah, just re-read your message. Remember to that MityVacs are pretty useless for bleeding hydraulics UNLESS you seal the threads going into the bleed screw with grease or something. Air can and will s; /html/spitfires/2001-01/msg00410.html (8,474 bytes)
4. Re: Clutch Hydraulics (score: 1): Author: "Ree Gurley" <reegurley@mindspring.com>; Date: Wed, 17 Jan 2001 16:43:01 -0600; SUCCESS! (Thanks, Jeff) Earlier today I said that "I rebuilt my slave and master cylinders" and now "I'm not getting full (clutch) release." Jeff McNeal suggested "Remove the slave cylinder, depress; /html/spitfires/2001-01/msg00414.html (7,480 bytes)
5. clutch hydraulics (score: 1): Author: A666K@aol.com; Date: Mon, 11 Jan 1999 13:48:31 EST; Hello, I got a clutch question. Daily driver spit (even when it is really cold), one day its hard to shift. I check fluid, there is none. I fill it, bleed it, drive it, all good. [At this time there; /html/spitfires/1999-01/msg00286.html (6,818 bytes)
6. Re: clutch hydraulics (score: 1): Author: GatesDavid@aol.com; Date: Mon, 11 Jan 1999 21:59:42 EST; It sounds to me like you need a slave cylinder rebuild kit. If you cannot find any fluid anywhere yet it is loosing fluid, it is probably going into the bell housing. Mine did this. It leaks out of t; /html/spitfires/1999-01/msg00294.html (7,549 bytes)

Current List: 1 - 6
Page: [1]