Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*draught\s+tube\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*draught\s+tube\s*$/: 6 ]

Total 6 documents matching your query.

1. draught tube (score: 1): Author: Unknown; Date: Tue, 28 Jul 1998 14:31:03 -0700 (PDT); I am going to rout a drain hole for my scuttle vent drain. Right now it sticks down and rains into the space between the footwell and the front fender. I have the hose, conections, and ability to bor; /html/triumphs/1998-07/msg01503.html (6,689 bytes)
2. Re: draught tube (score: 1): Author: Unknown; Date: Wed, 29 Jul 1998 00:56:15 -0700; I looked at your web page, Malcolm. You do have some rust to deal with! You need a little more "British undercoating"... loosen the valve cover and sump bolts and go for a drive! I wouldn't be too qu; /html/triumphs/1998-07/msg01520.html (9,890 bytes)
3. Re: draught tube (score: 1): Author: Unknown; Date: Wed, 29 Jul 1998 08:01:25 -0700 (PDT); When I pulled the fender there wasn't too much gunk (dirt) in there, but there sure was a lot of rust. I had it coming from all areas- there's not really one single culprit. Water from above, road st; /html/triumphs/1998-07/msg01545.html (8,256 bytes)
4. Re: draught tube (score: 1): Author: Unknown; Date: Wed, 29 Jul 1998 11:16:20 -0400 (EDT); The "L" at the end of your commission number means left hand drive. An "O" would indicate overdrive-equipped. As far as I'm aware there is no color code anywhere on the TR4 body. -- Chip Old 1948 M.; /html/triumphs/1998-07/msg01547.html (7,280 bytes)
5. Re: draught tube (score: 1): Author: Unknown; Date: Wed, 29 Jul 1998 17:14:08 EDT; << Does anyone have refernce to '62 color codes? I think my car was '62 chassis numbers don't have paint codes. The L means left hand steering. An O after the L means overdrive. Much simpler time, 19; /html/triumphs/1998-07/msg01559.html (6,860 bytes)
6. Re: draught tube (score: 1): Author: Unknown; Date: Thu, 30 Jul 1998 10:04:29 -0500charset="iso-8859-1"; You will need to cut the hose end at approximately a 45 degree angle pointing AWAY from the front of the car. Larry Zink Z Group Racing and Performance Houston, Texas --Original Message-- From Malco; /html/triumphs/1998-07/msg01598.html (7,346 bytes)

Current List: 1 - 6
Page: [1]