- 1. Engine Installation (score: 1)
- Author: City Of Antioch <billgegg@ci.antioch.ca.us>
- Date: Mon, 8 Nov 1999 08:05:51 -0800
- Help....Help....About two years ago, I pulled my Tiger engine for a rebuild. Yesterday, I went to re-install and ran into some problems. Specifically, I didn't get the engine installed. After removin
- /html/tigers/1999-11/msg00082.html (7,482 bytes)
- 2. Re: Engine Installation (score: 1)
- Author: MWood24020@aol.com
- Date: Mon, 8 Nov 1999 12:24:13 EST
- << After removing front cross member, I lifted engine from underneath, without the right side(starboard) header and spark plugs. With the transmission well below the engine and engine somewhat above
- /html/tigers/1999-11/msg00083.html (7,553 bytes)
- 3. Re: Engine Installation (score: 1)
- Author: Larry Paulick <larry.p@erols.com>
- Date: Mon, 08 Nov 1999 17:24:17 -0500
- Mike, I am converting to the 5.0L and when we test fitted the engine at the body shop, it would not go on with Rick's headers and motor moiunts, as you said. We then took off the right side headers a
- /html/tigers/1999-11/msg00085.html (7,169 bytes)
- 4. RE: Engine Installation (score: 1)
- Author: City Of Antioch <billgegg@ci.antioch.ca.us>
- Date: Mon, 8 Nov 1999 14:27:14 -0800
- Thanks for the reply. I had been thinking about loosening the left side headers as a next plan. Mine are not Rick's headers but are the CAT headers. Mike, I am converting to the 5.0L and when we test
- /html/tigers/1999-11/msg00086.html (7,694 bytes)
- 5. RE: Engine Installation (score: 1)
- Author: Tom Hall <modtiger@engravers.com>
- Date: Mon, 08 Nov 1999 18:54:14 -0800
- Mike Wood has the story essentially straight on installing headers , cast motor mounts, and rubber insulators simultaneously. Wrapping the mounts and header tubes with bubble packing material can red
- /html/tigers/1999-11/msg00088.html (8,282 bytes)
- 6. Re: Engine Installation (score: 1)
- Author: richards <richards@northcoast.com>
- Date: Mon, 08 Nov 1999 22:29:58 -0500
- Adding to what Tom said below......I also trimmed the steel motor mount platforms to allow for the header. I ground a bit out and then polished the recess smooth, followed by a repaint. Looks great a
- /html/tigers/1999-11/msg00089.html (8,913 bytes)
- 7. Re: engine installation (score: 1)
- Author: Robert Hogan <robhogan@freewwweb.com>
- Date: Sat, 08 Nov 1997 14:43:01 -0500
- My personal preference is to lower the engine and transmission assembly into place without the headers or engine mounts installed (using 2 upright beams and dual 2" x 8" lintels to support a chain fa
- /html/tigers/1997-11/msg00075.html (7,484 bytes)
This search system is powered by
Namazu