- 1. h6 float adj (score: 1)
- Author: Unknown
- Date: Fri, 23 Apr 1999 18:34:44 -0400
- Can anyone advise me on the correct diameter rod to use when adjusting the floats;one book says 7/16 dia. rod then I read that someone says 1/8-3/16 . These are h6 auc878 on a 59 tr3a Thanks Greg Gre
- /html/triumphs/1999-04/msg01288.html (6,268 bytes)
- 2. Re: h6 float adj (score: 1)
- Author: Unknown
- Date: Fri, 23 Apr 1999 17:34:06 -0500charset="iso-8859-1"
- I used a 7/16" drill bit. It works very well. Bob Kamholtz ECOD floats;one book says 7/16 dia. rod then I read that someone says 1/8-3/16 . These are h6 auc878 on a 59 tr3a
- /html/triumphs/1999-04/msg01291.html (6,792 bytes)
- 3. Re: h6 float adj (score: 1)
- Author: Unknown
- Date: Fri, 23 Apr 1999 21:48:02 EDT
- << Can anyone advise me on the correct diameter rod to use when adjusting the floats;one book says 7/16 dia. rod then I read that someone says 1/8-3/16 . These are h6 auc878 on a 59 tr3a Thanks Greg
- /html/triumphs/1999-04/msg01297.html (6,580 bytes)
This search system is powered by
Namazu