- 1. spridget axle shafts (score: 1)
- Author: Bryan Vandiver <Bryan.Vandiver@Eng.Sun.COM>
- Date: Tue, 26 Oct 1999 11:26:33 -0700 (PDT)
- While I was cleaning out and organizing all my extra sprite parts, I was over three extra rear axle half-shafts that I have. I noticed that one shaft is ~1/8 inch longer than the other two, as well a
- /html/spridgets/1999-10/msg01692.html (7,533 bytes)
- 2. Re: spridget axle shafts (score: 1)
- Author: Jeff Boatright <jboatri@emory.edu>
- Date: Tue, 26 Oct 1999 14:43:39 -0400
- The half shafts for steel wheels are longer than those for wire wheels (or is it the other way around?). As for compatibility, there may be a concern that fitting a shorter shaft to a longer axle hou
- /html/spridgets/1999-10/msg01694.html (8,471 bytes)
- 3. Re: spridget axle shafts (score: 1)
- Author: Gerard Chateauvieux <pixelsmith@gerardsgarage.com>
- Date: Tue, 26 Oct 1999 12:25:14 -0700
- There wouldn't be any difference between left and right except to have installed them on the same side from which they were removed. Of course you would have to have labeled them at the time to know
- /html/spridgets/1999-10/msg01702.html (8,744 bytes)
- 4. Re: spridget axle shafts (score: 1)
- Author: "Mike Gigante" <mikeg@vicnet.net.au>
- Date: Wed, 27 Oct 1999 09:37:50 +1000
- Maybe the longer one isn't a spridget half shaft? While there are not L or R half shafts made, they become L or R after use. if you use them on the wrong side, you are shortening their life (it is al
- /html/spridgets/1999-10/msg01732.html (8,980 bytes)
- 5. Re: spridget axle shafts (score: 1)
- Author: "Mike Gigante" <mikeg@vicnet.net.au>
- Date: Wed, 27 Oct 1999 09:40:05 +1000
- Except that the wire wheel half shafts are about an inch shorter than the steel wheel half shafts, not 1/8" longer. They also have the pressed on flange/splines whereas the steel wheel half shaft is
- /html/spridgets/1999-10/msg01733.html (9,367 bytes)
This search system is powered by
Namazu