Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*tech\s+Q\,\s+piston\s+rings\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*tech\s+Q\,\s+piston\s+rings\s*$/: 6 ]

Total 6 documents matching your query.

1. tech Q, piston rings (score: 1): Author: Unknown; Date: Thu, 6 Feb 2003 08:23:05 -0500; My flat-top pistons finally arrived yesterday! Quick question - I'm planning on checking the ring end gaps in the bores before assembling the rings into the bores. I'm assuming everything'll be OK, b; /html/spridgets/2003-02/msg00178.html (7,189 bytes)
2. Re: tech Q, piston rings (score: 1): Author: Unknown; Date: Thu, 6 Feb 2003 09:15:37 -0500; super job of squarely filing ring end gaps with a diamond dust wheel in a ring holding fixture. bore then use new piston to push ring square in bore. then feeler gauge end gap. (most production ring; /html/spridgets/2003-02/msg00179.html (8,825 bytes)
3. Re: tech Q, piston rings (score: 1): Author: Unknown; Date: Thu, 6 Feb 2003 09:17:54 -0500; since you are using flat top pistons, use the piston upside down to square the rings in the bore with hopes that the tops are squarely machined? using a piston upside down is far easier than right s; /html/spridgets/2003-02/msg00180.html (7,297 bytes)
4. Re: tech Q, piston rings (score: 1): Author: Unknown; Date: Thu, 6 Feb 2003 10:28:18 -0500; Figures there's a tool for this! ;) That's the plan. (and using the piston upside-down from the top, too.) I just wanted to find out what to do if something wasn't spot on. Thanks! -=Chris Chris King; /html/spridgets/2003-02/msg00181.html (7,829 bytes)
5. Re: tech Q, piston rings (score: 1): Author: Unknown; Date: Thu, 06 Feb 2003 10:45:46 -0500 (pop-3.dnv.wideopenwest.com); I've seen it done by clamping a fine file in a vice and gripping the ring so that the end gap "clamps" the file, working it back and forth to remove material. Gotta be careful, though. Chris K. /// u; /html/spridgets/2003-02/msg00182.html (8,180 bytes)
6. Re: tech Q, piston rings (score: 1): Author: Unknown; Date: Thu, 6 Feb 2003 21:02:07 EST; I bought one of these things on ebay for about 20 bucks. Chuck had also offered me his, but I figured by the time I paid for mailing back and forth... Don't over think this, it is actually alot easie; /html/spridgets/2003-02/msg00194.html (7,283 bytes)

Current List: 1 - 6
Page: [1]