Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Healeys\]\s+remountinbg\s+rear\s+bearing\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Healeys\]\s+remountinbg\s+rear\s+bearing\s*$/: 6 ]

Total 6 documents matching your query.

1. [Healeys] remountinbg rear bearing (score: 1): Author: Richard Kahn <tahoehealey@hotmail.com>; Date: Mon, 30 May 2011 18:16:09 -0700; I have removed the rear bearing in order to replace the seal. I am putting the same bearing back in. It came out easily but will not go the last 3 mms to sit against the new seal. I have used a vice; /html/healeys/2011-05/msg00728.html (6,984 bytes)
2. Re: [Healeys] remountinbg rear bearing (score: 1): Author: Alan Seigrist <healey.nut@gmail.com>; Date: Tue, 31 May 2011 11:46:38 +0800; The bearing is not designed to go all the way in and sit against the seal. If you read your manual about the rear bearing, it is supposed to protrude the surface a couple of MM, I don't know the exa; /html/healeys/2011-05/msg00731.html (8,262 bytes)
3. Re: [Healeys] remountinbg rear bearing (score: 1): Author: "BJ8 Healeys" <sbyers@ec.rr.com>; Date: Tue, 31 May 2011 09:43:17 -0400; The shop manual says: "When re-assembling [the bearing hub] it is essential that the outer face of the bearing spacer should protrude from .001 in. (.025 mm.) to .004 in. (.1 mm.) beyond the outer fa; /html/healeys/2011-05/msg00748.html (8,491 bytes)
4. Re: [Healeys] remountinbg rear bearing (score: 1): Author: Bob Spidell <bspidell@comcast.net>; Date: Tue, 31 May 2011 07:38:26 -0700; These instructions have always cornfused me. If the bearing is pressed against the "... abutment shoulder in the hub ..." there won't be much adjustment possible (unless you have a press strong enoug; /html/healeys/2011-05/msg00750.html (8,665 bytes)
5. Re: [Healeys] remountinbg rear bearing (score: 1): Author: "BJ8 Healeys" <sbyers@ec.rr.com>; Date: Tue, 31 May 2011 11:19:08 -0400; I agree that the instructions are a bit confusing. Without having engineering drawings of the hub or taking precise measurements of the hub and bearing, one would never actually know if the bearing i; /html/healeys/2011-05/msg00751.html (8,785 bytes)
6. Re: [Healeys] remountinbg rear bearing (score: 1): Author: warthodson@aol.com; Date: Tue, 31 May 2011 11:38:46 -0400; According to the parts book there was only one spacer available, (not several thicknesses to choose from). In my limited experience (four rear axle rebuilds) the bearing & spacer always have resulted; /html/healeys/2011-05/msg00752.html (10,772 bytes)

Current List: 1 - 6
Page: [1]