Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Healeys\]\s+trans\s+trouble\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Healeys\]\s+trans\s+trouble\s*$/: 4 ]

Total 4 documents matching your query.

1. [Healeys] trans trouble (score: 1): Author: Ralph Cap <rjcapo1@yahoo.com>; Date: Wed, 8 Jun 2011 12:19:06 -0700 (PDT); just installed a new clutch pressure plate bearing and a new slave cylinder bled the system and cannot get the car to go in gear used the alignment tool and tightened everything up any sugestions goi; /html/healeys/2011-06/msg00181.html (6,898 bytes)
2. Re: [Healeys] trans trouble (score: 1): Author: Tim Davis BN7 <tld6008@mchsi.com>; Date: Wed, 8 Jun 2011 15:33:22 -0500 (CDT); Can you shift the trans without the engine running? Step on clutch and operate starter, if car moves slave cyl isn't working or disc is stuck to pressure plate IMHO Tim Davis BN7 just installed a new; /html/healeys/2011-06/msg00183.html (7,563 bytes)
3. Re: [Healeys] trans trouble (score: 1): Author: "PG" <britishcars@shaw.ca>; Date: Wed, 8 Jun 2011 14:19:14 -0700; When you say "cannot get the car to go into gear", I assume you mean that it's grinding when you try? If so, it sounds like your input shaft is rubbing on the pilot bearing which means that when you; /html/healeys/2011-06/msg00185.html (8,833 bytes)
4. Re: [Healeys] trans trouble (score: 1): Author: "Tracy Drummond" <bighealey@charter.net>; Date: Thu, 9 Jun 2011 05:48:02 -0700; There are two thicknesses of throw out "bearings". Sounds like you used the thinner one when you replaced it. Was the new one thinner than the old one you pulled? If so this could be the culprit ass; /html/healeys/2011-06/msg00211.html (10,381 bytes)

Current List: 1 - 4
Page: [1]