- 1. [TR] Front Camber Adjustment - TR3 (score: 1)
- Author: Jonas Payne <jagmog@hotmail.com>
- Date: Fri, 24 May 2013 17:43:15 -0700
- After a long layup, I finally got my TR3 on the road again and noticed that the passenger side wheel has about 1/2" of positive camber - which is about 3/4" the wrong way. I don't see any adjustment
- /html/triumphs/2013-05/msg00259.html (8,424 bytes)
- 2. Re: [TR] Front Camber Adjustment - TR3 (score: 1)
- Author: "Andrew Uprichard" <auprichard@uprichard.net>
- Date: Fri, 24 May 2013 22:25:09 -0400
- There is no adjustment for camber. Did you replace the ball joints? Some aftermarket ball joints have the hole for the pin in the wrong position: if you do not tighten the whole way, you will end up
- /html/triumphs/2013-05/msg00260.html (9,907 bytes)
- 3. Re: [TR] Front Camber Adjustment - TR3 (score: 1)
- Author: "Randall" <TR3driver@ca.rr.com>
- Date: Fri, 24 May 2013 21:33:58 -0700
- Er, no, TR3s are designed with positive camber. The spec is 2 degrees (positive) "static laden", which is just about 1/2" measured across the width of the wheel. Sounds like your real problem is lac
- /html/triumphs/2013-05/msg00261.html (8,896 bytes)
- 4. Re: [TR] Front Camber Adjustment - TR3 (score: 1)
- Author: Jonas Payne <jagmog@hotmail.com>
- Date: Sat, 25 May 2013 06:55:44 -0700
- I have my cambers messed up (again) camber is negative on pass side positive on drivers Sent from my iPhone the ** triumphs@autox.team.net ** Archive: http://www.team.net/archive
- /html/triumphs/2013-05/msg00262.html (9,541 bytes)
This search system is powered by
Namazu