Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[TR\]\s+Oil\s+pressure\s+in\s+my\s+TR6\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[TR\]\s+Oil\s+pressure\s+in\s+my\s+TR6\s*$/: 7 ]

Total 7 documents matching your query.

1. [TR] Oil pressure in my TR6 (score: 1): Author: Joe DeMuth <jdemuth@ties2.net>; Date: Thu, 23 May 2013 17:35:34 -0500; Help. Just bought a '73 TR6 after selling the TR3 I owned for thirty years. Everything looked good about this car, but I soon became concerned with the oil pressure reading. At idle, running 20-50 oi; /html/triumphs/2013-05/msg00236.html (9,335 bytes)
2. Re: [TR] Oil pressure in my TR6 (score: 1): Author: Bob Labuz <yellowtr@adelphia.net>; Date: Thu, 23 May 2013 19:00:19 -0400; Joe, Make sure you check the thrust washer clearance. It is a known week link for the 6 engine. If it is not in spec, replace with upgraded washers. What oil/weight are you using? Make sure you use a; /html/triumphs/2013-05/msg00237.html (10,642 bytes)
3. Re: [TR] Oil pressure in my TR6 (score: 1): Author: Dave Massey <dave1massey@cs.com>; Date: Thu, 23 May 2013 22:37:11 -0400 (EDT); That sounds a little low but no terminally so. You may have excess clearances in the oil pump and a fresh pump may improve things significantly. Camshaft clearances also help determine oil pressure b; /html/triumphs/2013-05/msg00242.html (10,128 bytes)
4. Re: [TR] Oil pressure in my TR6 (score: 1): Author: <glemon@neb.rr.com>; Date: Fri, 24 May 2013 12:29:53 +0000; I agree with what Dave said. While the numbers are lower than you will see for a fresh motor, or even a well worn one in good nick, I have driven many motors many miles with similar numbers and nothi; /html/triumphs/2013-05/msg00243.html (12,203 bytes)
5. Re: [TR] Oil pressure in my TR6 (score: 1): Author: <glemon@neb.rr.com>; Date: Fri, 24 May 2013 06:42:43 -0700; I agree with what Dave said. While the numbers are lower than you will see for a fresh motor, or even a well worn one in good nick, I have driven many motors many miles with similar numbers and nothi; /html/triumphs/2013-05/msg00244.html (12,226 bytes)
6. Re: [TR] Oil pressure in my TR6 (score: 1): Author: Chris Kantarjiev <cak@dimebank.com>; Date: Fri, 24 May 2013 09:51:14 -0700; Those pressures seem totally reasonable; my target is usually 10PSI/1000rpm. Too high an oil pressure is just robbing power from the engine. One thing you didn't look at, and is not an uncommon probl; /html/triumphs/2013-05/msg00248.html (8,578 bytes)
7. [TR] Oil Pressure in My TR6 (score: 1): Author: Joe DeMuth <jdemuth@ties2.net>; Date: Sun, 26 May 2013 11:02:55 -0500; Thanks all for the responses. When I wrote the original message I forgot to mention that I had checked the thrust washers. I did look at the rocker shaft and it appears to have been replaced by a pre; /html/triumphs/2013-05/msg00267.html (8,318 bytes)

Current List: 1 - 7
Page: [1]