Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Tigers\]\s+Heater\s+valve\s+cable\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Tigers\]\s+Heater\s+valve\s+cable\s*$/: 3 ]

Total 3 documents matching your query.

1. [Tigers] Heater valve cable (score: 1): Author: Brent Edinger <banana111@msn.com>; Date: Fri, 12 Dec 2014 12:53:31 -0800 FILETIME=[B06B0180:01D0164D]; Anybody know an easy way to replace a heater control valve cable? the old one was cut off short under the dash so I can't use the old one to help route a new one. Looking up in there it appears to be; /html/tigers/2014-12/msg00031.html (8,189 bytes)
2. Re: [Tigers] Heater valve cable (score: 1): Author: " Ron Fraser" <rfraser@bluefrog.com>; Date: Fri, 12 Dec 2014 17:28:16 -0500; Brent 1 I would try shrink tubing to tie the new cable to the old one on the engine side then push it through. Probably, it would help to have someone under the dash to help feed the cable. 2 Tie som; /html/tigers/2014-12/msg00032.html (9,750 bytes)
3. Re: [Tigers] Heater valve cable (score: 1): Author: ironbeast <ironbeast@comcast.net>; Date: Fri, 12 Dec 2014 17:45:04 -0500; Hi Brent. B I just recently did this and found its not as hard as it seems. B The trick is to tape something stiff to the end of the cable. I think I used a 3/16" rod and gorilla taped it. Put a ligh; /html/tigers/2014-12/msg00033.html (10,130 bytes)

Current List: 1 - 3
Page: [1]