Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Tigers\]\s+Holley\s+Rebuild\s+\-\s+float\s+bowls\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Tigers\]\s+Holley\s+Rebuild\s+\-\s+float\s+bowls\s*$/: 6 ]

Total 6 documents matching your query.

1. [Tigers] Holley Rebuild - float bowls (score: 1): Author: Jay Laifman <jay.laifman@gmail.com>; Date: Tue, 11 Jun 2013 22:00:59 -0700; So I've proceeded a bit more on the carb. The back float bowl was a disaster. The gasket was really stuck on the carb. I used the chemical gasket remover. But it wasn't all that much help. And, the c; /html/tigers/2013-06/msg00106.html (9,164 bytes)
2. Re: [Tigers] Holley Rebuild - float bowls (score: 1): Author: genepadgett@comcast.net; Date: Wed, 12 Jun 2013 06:04:53 +0000 (UTC); Holleys are supposedly very sensitive to float levels being set properly. Not knowing how the motor was running before, it is hard to guess for what he may have been compensating. Was it running rich; /html/tigers/2013-06/msg00107.html (11,722 bytes)
3. Re: [Tigers] Holley Rebuild - float bowls (score: 1): Author: Gary Winblad <garywinblad@comcast.net>; Date: Wed, 12 Jun 2013 14:27:11 +0000 (UTC); Oh Jay... I feel your pain!! It brings it all back.. yup, your Holley must be from the same vintage as my 4bbl. Now my much older 2bbl never had those stuck forever gaskets. Be sure to use the plain; /html/tigers/2013-06/msg00110.html (10,876 bytes)
4. Re: [Tigers] Holley Rebuild - float bowls (score: 1): Author: "Smit, Theo" <Theo.Smit@dynastream.com>; Date: Wed, 12 Jun 2013 14:28:46 +0000; Too-high floats are usually more trouble than too-low floats because you can get unintended flooding during hard cornering or braking. If your needle and seat size is marginal (or if the fuel pump/fu; /html/tigers/2013-06/msg00111.html (10,949 bytes)
5. Re: [Tigers] Holley Rebuild - float bowls (score: 1): Author: Gary Winblad <garywinblad@comcast.net>; Date: Wed, 12 Jun 2013 15:05:26 +0000 (UTC); Also, The "rebuild" level is probably a low level just to get you going. The instructions are to always set the level wet after installation. Float level has a minor(?) influence on mixture. Your dad; /html/tigers/2013-06/msg00114.html (11,459 bytes)
6. Re: [Tigers] Holley Rebuild - float bowls (score: 1): Author: jay.laifman@gmail.com; Date: Wed, 12 Jun 2013 15:31:41 +0000; I'm worried that he never knew the bowls were way off and adjusted jets to compensate. It wouldn't be like him. But we'll see what happens when I reset them. The problem is that one is so off that th; /html/tigers/2013-06/msg00116.html (13,211 bytes)

Current List: 1 - 6
Page: [1]