Last year I replaced my worn out fiber-board tranny tunnel with the hard
plastic replacement. My backup light switch was bad and I replaced it
too on the tranny. At the time I didn't notice that the new switch sticks
out a little higher than the original.
After everything was put back together my backup lights failed after
about three months of operation. I suspect that the cover squeezed down
the switch terminals. Has anyone ever had this problem and how did you
fix it without ripping out the interior.
Very irritated in Connecticut,
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today! For your FREE software, visit: