6pack
[Top] [All Lists]

Re: Turn signal wires leaking smoke..

To: "Chris David" <cdavid@direcway.com>, <6pack@autox.team.net>
Subject: Re: Turn signal wires leaking smoke..
From: <dmurray1961@adelphia.net>
Date: Thu, 8 Jul 2004 19:31:57 -0400
Digi-Key Electronics Supply (www.digikey.com) has a huge selection of 
electronics components, switches, cabling, and hardware, including heat shrink 
tubing in various lengths and diameters.  Ship small and large quantities same 
day.

Or any local Radio Shack...

Dave
> 
> From: "Chris David" <cdavid@direcway.com>
> Date: 2004/07/07 Wed PM 09:16:31 EDT
> To: <6pack@autox.team.net>
> Subject: Turn signal wires leaking smoke..
> 
> In order to save some viewers the agony of reading all of this I will post the
> question at the beginning (and end) of this RFI.
> 
> -----------------------------------------------------------------------------
> ---
> 
> Anyone have a suggestion as to where to get heat- shrink tubing in various
> lengths and diameters?
> 
> -----------------------------------------------------------------------------
> ---
> 
> I made mention of my car smoking whenever I took it for a spin.  Took the dash
> and other wires out today... seems two of the three turn-signal wires have
> been worn down past the insulation (which in turn caused my white ignition
> wire to leak smoke from under the dash.   I'm not one for making the car show
> quality but tend to drift towards the "make it better than the condition that
> caused the failure" attitude.
> 
> The wires are worn away about 1" from the switch itself (but still inside the
> steering column and not in the small tunnel it later ventures down.  I have to
> assume it was touching the actual steering shaft as this is the moving part
> (and what was causing the smoke was the shaft shorting out the wires while
> turning (it never smoked while standing still)
> 
> Therefore.. I want to tear off the black tape wrapped around the wires, remove
> the less than effective rubber shrouds over the wires (where it wore through)
> and replace it with more modern heat shrink tubing on each wire for more than
> an inch and then use heat shrink over the complete wiring assy. in lieu of the
> previous tape wrap.
> 
> Anyone have a suggestion as to where to get heat shrink in various lengths?





<Prev in Thread] Current Thread [Next in Thread>