If you're talking about the cable that connects to the heater control valve
at the engine, there's a clamp that holds the outer cover in place so the
inner wire can move. If you need a picture, let me know.
Bob Danielson
1975 TR6 CF38503U
Running w/ Throttle Body Injection
Toyota 5 Speed & Nissan LSD
http://tr6.danielsonfamily.org
-----Original Message-----
From: 6pack-bounces@autox.team.net [mailto:6pack-bounces@autox.team.net] On
Behalf Of acekraut11@aol.com
Sent: Sunday, November 02, 2008 1:09 PM
To: rpeglow@optonline.net; 6pack@autox.team.net
Subject: Re: [6pack] heater valve control cable
Bob,
The outer sheath has a clamp that is held by a screw under the dash.? You
should be able to look under the dash on the drivers side above the gearbox
hump and see right where the clamp is.
Aaron
Aaron Cropley
71 TR6 (Throttle Body Injection!)
http://www.triumphowners.com/108
2002 Mini Cooper S
Topsham, Maine
-----Original Message-----
From: Bob <rpeglow@optonline.net>
To: 6pack@autox.team.net
Sent: Sun, 2 Nov 2008 3:07 pm
Subject: [6pack] heater valve control cable
Hello,
Heater control cable hardly moves center wire at heat control valve.
Dashboard end moves properly, so it seems the outer sheath has come loose
on control side. Is there something that comes loose and can be tightened or
is this the way these cables usually fail? Thank you and regards, Bob
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
You are subscribed as 75tr6@tr6.danielsonfamily.org
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|