6pack
[Top] [All Lists]

Re: [6pack] #4 main bearing cap needed

To: vance.navarrette@intel.com, LOddTR@aol.com, 6pack@autox.team.net
Subject: Re: [6pack] #4 main bearing cap needed
From: Timbo00001@aol.com
Date: Tue, 18 Nov 2008 10:36:09 EST
Please remove me from the distribution.
 
 
In a message dated 11/18/2008 10:24:16 A.M. Eastern Standard Time,  
vance.navarrette@intel.com writes:

Leo:

The bearing caps are machined at the factory  in place on the block due to the
tight tolerances needed for the main  bearings. They cannot be swapped between
blocks, and they must be installed  in the proper orientation. In short, if
your bearing cap is toast, you  cannot source a used one to replace it without
extensive machining of the  cap and block to get it to fit. This is why they
are generally unavailable  as a replacement part.
Your best bet is to have your existing  bearing cap welded, and machined to
repair it. However, if you are doing  this, there is a good chance that after
all the machining and line boring  you will have more into it than a used 
block
will cost. Consider replacing  the block with a used one from any of the
British  wrecking yards as  an alternative.

Vance


Vance  Navarrette
Cogito Ergo Zoom
I think,  therefore I go fast

-----Original Message-----
From:  6pack-bounces@autox.team.net [mailto:6pack-bounces@autox.team.net]  On
Behalf Of LOddTR@aol.com
Sent: Monday, November 17, 2008 3:00  PM
To: 6pack@autox.team.net
Subject: [6pack] #4 main bearing cap  needed

I am in need of a good used #4 main bearing cap for a late TR6.  Please
contact me off-list if you have one available.

Leo  Oddi
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack

http://www.team.net/archive

You  are subscribed as  timbo00001@aol.com
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack

http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>