When I first started tinkering with the carbs on my car many years ago I had a
similar problem in which a damper piston was binding. It seemed that somehow
when I screwed the four screws on the top down the top wasn't seating exactly
straight. I finally solved the problem by continually working the piston up
and down while tightening the screws. I have not had this problem on any
of the many other carbs I have worked on since then so I'm not sure what
caused it that one time, It could have been a carb needle as someone
suggested but once I got rid of the hang up it worked just fine. YMMV.
Mike
Lunsford, 1970 TR6
_______________________________________________
6pack@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|