I would fill the outer part of the holes with JB weld to keep them from backing
out.
Lou
72 Pimento
------Original Message------
From: Alex
Sender: 6pack-bounces@autox.team.net
To: Robert Liam Gannon
To: TR-6 list
To: 'Sally or Dick Taylor'
Subject: Re: [6pack] Free spinning fan-follow up
Sent: May 31, 2010 8:15 PM
Excellent point. My pins move pretty freely.
May be doing this again shortly. :o(
----- Original Message -----
From: "Robert Liam Gannon" <trsix74@comcast.net>
To: "'Alex'" <ambritts@bellsouth.net>; "'*Six Pack'" <6pack@autox.team.net>;
"'Sally or Dick Taylor'" <tr6taylor@webtv.net>
Sent: Monday, May 31, 2010 9:10 PM
Subject: RE: [6pack] Free spinning fan-follow up
> You never know what is going to happen next. I suspect the pins were not
> lined up with the holes on the harmonic balancer and therefore pushed out
> as
> the big bolt was tightened. Those pins are pressed in and are pretty tough
> to move.
_______________________________________________
6pack@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: http://autox.team.net/mailman/options/6pack/lfm614@aol.com
_______________________________________________
6pack@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|