That sounds good Bud,
Cover tem in Marine Grease. Much better than WD40!!!
Thanks,
Darrell
In a message dated 9/27/2010 3:27:26 P.M. Eastern Daylight Time,
levilevi@comcast.net writes:
Darrell,
If the noise comes back try dabbing marine wheel bearing grease (its a
blue/green color) around the edges of the bushings and any interface
that might "take up" the grease. My front sway bar urethane bushings
started to make noise after being installed and I DIDN'T know to
grease them beforehand so on advice from the list I tried the marine
grease and they quieted down and haven't had a problem since (12
years)...except that now that I've said that I'll probably regret it.
Bud Rolofson
71TR6 CC57365 (Good 6)
66TR4A CTC57806 (The Wreck-Almost parts)
66TR4A CTC57529 (The Project)
71F-250 Camper Special (Triumph Support Vehicle)
Z-50A Hardly Davidson 1977 Honda Mini-Trail Bike (Triumph Pit Bike)
levilevi@comcast.net
On Sep 27, 2010, at 8:39 AM, TR250Driver@aol.com wrote:
> So I squirted some WD40 all over and let it sit
> overnite. The noise is now gone.
_______________________________________________
6pack@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|