I encountered the same thing. The problem seemed to be that the hole in
the knob was not large enough to allow the ball(or pin) on the shaft to
enter it sufficiently. I opened mine up just slightly with the
appropriate size drill. Once opened up, the knobs stay on fine. John
Mitchell 76 TR6 72 Stag
On 6/14/2011 6:26 PM, David Friedlander wrote:
> Ken;
>
> As I recall, I've ordered several set over the years, one from TRF, the
> other from
> Moss. None of the newer knobs seem stayed on their assigned locations unless
>
> I spot-glued them on. They just never snapped into position on the shafts
> the
> way the originals did, even though I've tried to lube the pins on each shaft
> and
> make sure the knobs has holes for the pins.........
>
> Just a bit of a heads-up, in case you encounter the same thing...
>
> Dave
> '74-Six
>
>
> On Tue, Jun 14, 2011 at 5:29 PM, Ken Davis<ken@azkiwis.com> wrote:
>
>> I know I'm getting a new set of dash knobs for fathers day -- they arrived
>> today -- and have a couple of questions.
>>
>> Seems I must insert a small rod in the hole to release the pin holding the
>> old
>> ones on.
>>
>> I've tried that, but no success. So I'm wondering if I can insert the rod
>> to
>> depress the pin and then with a large pair of pliers, grab and shake the
>> knob
>> while trying to pull it off?
>>
>> Recommended? or any other tricks I might want to try?
>>
>>
>>
>>
>> Ken
>> 73 TR6
>>
>> ________________________________________
>>
>> 6pack@autox.team.net
>>
>> Donate: http://www.team.net/donate.html
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe:
>> http://autox.team.net/mailman/options/6pack/forzion7@gmail.com
> ________________________________________
>
> 6pack@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/6pack/jmitch@snet.net
________________________________________
6pack@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|