6pack
[Top] [All Lists]

Re: [6pack] Nissan LSD conversion question

To: michael lunsford <mblunsfordsr@yahoo.com>, 6pack@autox.team.net
Subject: Re: [6pack] Nissan LSD conversion question
From: Bill <anabil007@comcast.net>
Date: Thu, 23 Jun 2011 11:22:32 -0700
At 10:47 AM -0700 6/23/11, michael lunsford wrote:
>I have Richard Good's Nissan Differential upgrade with a Q-45 differential in
>my

Perhaps this might be the reason ...

NOTE: Installation of Good Parts rear Nylatron suspension bushing kit 
is strongly recommended when installing the R200 differential. The 
original type rubber bushings allow the trailing arm to shift 
sideways during hard cornering. This action, combined with binding of 
the axle splines during acceleration or deceleration has, on a few 
occasions disengaged the internal snap ring hold the R200 axle stub 
into the differential. If the axle stub moves out far enough to 
disengage its splines, power cannot be transmitted to the wheels. 
This has not been known to occur on cars using the Nylatron bushings 
in the trailing arms. Springs are now supplied with the R200 
installation kit to install between the axle half-shafts as an extra 
precaution.

I would urge you to use the Nylatron kit ...

-- 
"Thinking is the hardest work there is. That's why so few people 
undertake it." - Henry Ford
Bill Pugh
1957 TR3
"Casper"
TS16765L
Wallace, CA

________________________________________

6pack@autox.team.net

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums


<Prev in Thread] Current Thread [Next in Thread>