| To: | jsrlee@shaw.ca, alpines@autox.team.net |
|---|---|
| Subject: | Re: Fuel Sender Unit Removal |
| From: | JACranwell@aol.com |
| Date: | Mon, 10 May 2004 06:12:35 EDT |
Ryan, No special tools are needed. A blunt screwdriver, or a drift does the job. Just rotate counter-clockwise to remove, and opposite to re-install. Check the state of the the rubber seal, once removed, and replace if damaged. Regards, Julian. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | rootes od & 4spd transmission, Mike |
|---|---|
| Next by Date: | RE: Heater Core?, SwampFox |
| Previous by Thread: | Fuel Sender Unit Removal, Ryan Lee |
| Next by Thread: | 64 series iv alpine (fwd), tjhiggin |
| Indexes: | [Date] [Thread] [Top] [All Lists] |