Hi Aaron,
how are you
Is the slave cylinder on the right side of the bell housing ?
Have someone operate the pedal and see how much travel there is in the
slave cylinder - if you are not getting much movement its a hydraulic
issue
I have some kits of you need one.
regards
Jeff
In message
<c0ce1dba0909050527j760f8d64u6847e67071b954b1@mail.gmail.com>, aaron
martin <azza.martin@gmail.com> writes
>Hi all,
>
>Im a new member and am a proud owner of a 53,000 mile 1964 series 4 GT.
>
>I am got an issue with the clutch at the moment ( as it the clutch is
>not working at all!), however it use to be ok for a while if i pumped
>the pedal for a while.
>Clutch fluid level looks fine, cant see it leaking anywhere, im
>assuming its either by-passing at the master/slave cylinders. If this
>a common issue?? where should i start?
>
>Thanks
>
>Aaron
>_______________________________________________
>Support Team.Net http://www.team.net/donate.html
>
>Alpines@autox.team.net
>http://autox.team.net/mailman/listinfo/alpines
>
>http://www.team.net/archive
>
--
Jeff Howarth
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Alpines@autox.team.net
http://autox.team.net/mailman/listinfo/alpines
http://www.team.net/archive
|