Wouldn't it be :
opposite/hypotenuse = sine of theta
so ....opposite is in inches of toe, hypotenuse is 1/2 the tire diameter
(radius) , and theta is your degrees of toe....
So,
# of inches divided your tire radius is the sine of the angle in degrees?
~rick shank
On Fri, 30 Nov 2001, Tom Holt wrote:
> It should be:
> Tire Diameter * sine of the Angle = Toe in inches
>
> Tom
> ----- Original Message -----
> From: Pete Holsberg <pjh@mccc.edu>
> To: <autox@autox.team.net>
> Sent: Friday, November 30, 2001 1:10 PM
> Subject: Toe inches & degrees
>
>
> > The printout for my last wheel alignment showed that toe
> > was measured in inches, but the factory manual shows it in
> > degrees.
> >
> > How do I convert from one to the other?
> >
> > Thanks,
> > Pete
> >
> > /// autox@autox.team.net mailing list
> > ///
> > /// To unsubscribe send a plain text message to majordomo@autox.team.net
> > /// with nothing in it but
> > ///
> > /// unsubscribe autox
> > ///
> > /// or try http://www.team.net/cgi-bin/majorcool
> > ///
>
> /// autox@autox.team.net mailing list
> ///
> /// To unsubscribe send a plain text message to majordomo@autox.team.net
> /// with nothing in it but
> ///
> /// unsubscribe autox
> ///
> /// or try http://www.team.net/cgi-bin/majorcool
> ///
/// autox@autox.team.net mailing list
///
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe autox
///
/// or try http://www.team.net/cgi-bin/majorcool
///
|