Okay, I told you I was going to ask more questions. I just bought an 80cc
shifter kart, which I'm going to tow behind the MR2. Nobody makes a plug-in
wiring harness for it (towing with an MR2??), so I bought a generic, 4-wire
connector to match the plug on the trailer. I don't have a great grasp of
electricity, but I don't see how I can set the trailer up (using the current
4-wire plug) to have turn signals without causing the car's turn signals to
come on under braking? Any suggestions?
Also: what's the preferred techniqe for splicing the wires in? Are you
s'posed to solder them, or can I use those little pincher thingies, or wire
nuts?
Thanks! I bow in ignorance before the collected wisdom of ba-autox.
Phil
________________________________________________________________________
|