bmcu
[Top] [All Lists]

Re: [Bmcu] Suggested Drives?

To: jon@jonzaremba.com, bmcu@autox.team.net
Subject: Re: [Bmcu] Suggested Drives?
From: rgood36362@aol.com
Date: Tue, 11 Sep 2007 15:58:27 -0400
Two suggestions:

?

Trapper's Loop/Old Snowbasin road:

Go up I-84 (only have to do about 6 miles of freeway), get off at Mountain 
Green and follow the signs to Snowbasin.? After hitting the resort, continue on 
the old Snowbasin road (lots of twisties) to where it drops down to Pineview 
reservoir.? For there, take a right and do a loop around the lake, or left and 
head down Ogden canyon.? 

Emigration/East Canyon:
Start out like you're going for Trapper's loop, but instead of following the 
signs to Snowbasin, continue on the old road to Morgan.? Head up east canyon, 
take a swing around the east shore of the lake, and keep heading south.? When 
you get to Emigration canyon, you can turn right, do the twisties, and go past 
the zoo and This is the Place.? Or continue going straight and end up on I-80 
about 2/3 of the way down Parley's canyon.

Rich Goodman


-----Original Message-----
From: Jon Zaremba <jon@jonzaremba.com>
To: BCMU <bmcu@autox.team.net>
Sent: Tue, 11 Sep 2007 9:38 am
Subject: [Bmcu] Suggested Drives?




Hi Gang,

Well, the weather couldn't be finer this week!  I'm still learning some of 
Utah's best kept secret roads.  Does anyone have any suggestions on some of 
their favorite drives in the area?  Perhaps some nice wooded non-highway 
(but paved) roads that aren't too obvious when browsing Mapquest?

Thanks,
Jon Zaremba
79 B
80 Cressida 
_______________________________________________
Bmcu mailing list
Bmcu@autox.team.net
http://autox.team.net/mailman/listinfo/bmcu


________________________________________________________________________
Email and AIM finally together. You've gotta check out free AOL Mail! - 
http://mail.aol.com
_______________________________________________
Bmcu mailing list
Bmcu@autox.team.net
http://autox.team.net/mailman/listinfo/bmcu

<Prev in Thread] Current Thread [Next in Thread>