| To: | <match@ece.utah.edu>, <bmcu-bounces@autox.team.net>, <Bmcu@autox.team.net> |
|---|---|
| Subject: | Re: [Bmcu] 57 TR3 head studs not lined up? |
| From: | "Ron Christensen" <ron.christensen@wsapr.com> |
| Date: | Fri, 28 Sep 2007 15:10:39 -0600 |
Additional advice from a BMC expert in LaVerne California: If heating the block does not result in proper fit of the head gasket you must re-heat it with more humidity, the previous heat may have been too dry. Failing that, you may just have to rent the block-stretcher from Moss Motors, Standard Motors Special Tool #E110576-BS. _______________________________________________ Bmcu mailing list Bmcu@autox.team.net http://autox.team.net/mailman/listinfo/bmcu |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Bmcu] 57 TR3 head studs not lined up?, Ron Christensen |
|---|---|
| Next by Date: | Re: [Bmcu] 57 TR3 head studs not lined up?, Ron Christensen |
| Previous by Thread: | Re: [Bmcu] 57 TR3 head studs not lined up?, Ron Christensen |
| Next by Thread: | Re: [Bmcu] 57 TR3 head studs not lined up?, Ron Christensen |
| Indexes: | [Date] [Thread] [Top] [All Lists] |