bricklin
[Top] [All Lists]

[Bricklin] u joint

To: <Bricklin@autox.team.net>
Subject: [Bricklin] u joint
From: "Larry Ankeny" <lvphotogroup@cox.net>
Date: Fri, 15 Jul 2011 21:11:01 -0700
I was finally able to get the yoke nut off to replace the seal, but when I 
disconnected the u joint, one of the ends came off and all of these little 
rods or rollers came out.

anybody have a part number or can tell me what the u joint crosses to?

Larry in LV
#2046

----- Original Message ----- 
From: "Greg Schroeder" <gschroeder@comcast.net>
To: <Bricklin@autox.team.net>
Sent: Monday, July 11, 2011 8:32 PM
Subject: [Bricklin] Heater Control Cable


> Anyone have a part number or source for a heater control cable.  This is 
> the
> cable that goes from the air control panel to the heater control.
>
> Mine is worn and slides through the clip that is suppose to hold the wire 
> in
> the fixed position so wire can close and open the heater control
>
> Greg 0036
> _______________________________________________
> Bricklin@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation  $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/bricklin/lvphotogroup@cox.net
>
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1388 / Virus Database: 1516/3758 - Release Date: 07/11/11
_______________________________________________
Bricklin@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>