buick-rover-v8
[Top] [All Lists]

Re: Correct way to install Felpro Head Gaskets

To: "Larry list account" <list@marketvalue.net>, <mgb-v8@autox.team.net>,
Subject: Re: Correct way to install Felpro Head Gaskets
From: "Allen Wulf" <wulfmgbv8@comcast.net>
Date: Tue, 11 Nov 2003 16:51:21 -0700
----- Original Message -----
From: "Larry list account" <list@marketvalue.net>
To: <mgb-v8@autox.team.net>; "'Buick-Rover V8 Group'"
<buick-rover-v8@autox.team.net>
Sent: Tuesday, November 11, 2003 6:41 AM
Subject: RE: Correct way to install Felpro Head Gaskets


> > Don't think mine were Felpro, but they were marked 'TOP'.
>
> Paul, Al's friend is also my friend.  I too spoke to him about his
gaskets.
> Turns out his gaskets don't say 'top' or 'front' or anything.  So the
> installation procedure is a bit of a mystery.
>
> I suggested to him that the metalized side goes to the 'hot' side, which I
> would believe to be the heads.  But frankly I am not sure.
>
> Larry
>
Paul,
The next question would be:  Is the side marked  'TOP' metal?  I'm assuming
that the gasket you are using is a composition rather than a steel shim.

Al

///
///  buick-rover-v8@autox.team.net mailing list
///


<Prev in Thread] Current Thread [Next in Thread>