Call Autopower and have them send one that fits, or find a friend with a saw
and a welder ;-)
> Mine is already mounted as low on the slope of the floor as possible and
the
> rear braces bolt on the shelf in front of the rear shock cross member. I
> had to cut away part of the hat channel under the shelf to clear two
bolts.
> Now what?
>
> Paul
> -----Original Message-----
> From: Rob Robinson <FastrTime@T-Three.com>
> To: Paul <9laser3@bright.net>; datsun-roadsters@autox.team.net
> <datsun-roadsters@autox.team.net>
> Date: Friday, May 07, 1999 6:25 PM
> Subject: Re: Soft top VS roll bar!
>
>
> >My Autopower bar will not clear the soft top either - if the bar is
> >installed in the factory holes. I moved the bar forward about 3", placing
> >the rear support mounts directly above the rear shock crossmember. The
top
> >clears the bar in this location.
> >
> >Rob Robinson
> >CSP 67 2000
> >Roanoke, Va
> >
> >----- Original Message -----
> >From: Paul <9laser3@bright.net>
> >To: <datsun-roadsters@autox.team.net>
> >Sent: Friday, May 07, 1999 9:42 PM
> >Subject: Soft top VS roll bar!
> >
> >
> >> I just installed an AutoPower street roll bar this spring and now my
> >soft
> >> top frame won't clear the bar. The rear most loop, the adjustable one,
> >hits
> >> each side of the roll bar. Any ideas?
> >>
> >> Paul
> >> 1969 1600
> >> OROC
> >>
> >>
> >
>
>
|