In a message dated 6/12/00 9:17:53 PM EST, NRUFFCORN@prodigy.net writes:
<< Believe it or not, tonight I had all but given up and had begun prepping
the rings to glass bead them and paint them while on the gauges. If there is
an easier way, I
am very open to suggestions! >>
Hello,
It is very difficult to remove the trim from the gauges. Easy to beak the
glass too. <Trust me on that one> Anyway, my rigs were pitted and slightly
rusted too so I sanded them down and masked them and repainted them. They
came out very nice. But I didn't go stock black. I went to silver. I
know... I know... but I dont care. I like silver better than black.
Dont attempt to remove the rings. I was extremely careful and was quite
unsuccessful.
Calspeed
67.5 SRL311-000248 Solex
|