I had some success using steel wool wrapped around the tip
of a small screwdriver or similar to scrape around inside the
female electrical receptacles.
The same steel wool alone is fine to clean the male connectors,
just rub. If I had any contact cleaner, I'd use that afterwards.
Tom.
'68 SPL311
Sunnyvale CA.
----- Original Message -----
From: "Daniel Neuman" <dneuman@quark.sfsu.edu>
To: <datsun-roadsters@autox.team.net>
Sent: Friday, September 13, 2002 2:16 PM
Subject: Electical connector cleaning?
> Hello All,
> We have decided that this Sat is going to be clean up the electrical
> contacts on the cars day. I get to do the car stuff and Irene has to
finish
> painting the guest bathroom.
> I plan on starting at
> the front of the car and working all the way to the tail lights. I will
clean the frame grounding points and replace
> corroded cables. I will clean the male half of all connections. My
question is, how do you clean the female half of
> the electrical connections? How do you get down into the female side of a
bullet connector? or a spade connector?
> Thanks,
> Daniel 69 2000
> Oakland CA
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Archives at http://www.team.net/archive
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|