List,
My car is still not running very well. I've switched out the
points/plugs/condensor/rotor/and cap with new Nissan parts. I checked
the resistor and that is fine. The car will run well for the first 10-20
minutes then feel sluggish under load. This normally happens around
3000-4000 rpm. One of the things that I noticed was that when I was
checking the timing was that the timing didn't advance much over 20
degrees when I was reving the engine (checked with the vacuum removed).
If I remember correctly this should advance quite a bit when the engine
is reved.
Thanks for any insites,
Dana
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|