Re: rear-end swap

[<efrisbee@charter.net>]

All you need is the 2000 rear end gears... everything else is identical on 
2000s and 1600s. Good luck!!

Eric

> 
> Hello,
>  
> I spun a bearing on my 2000 solex engine and am in the process of
> rebuilding the motor. I'm now thinking of exchanging the entire drive
> train from my ratty 2000 body and installing it into my almost restored
> 1600. My question is, can I switch out the rearend gearing or must I
> completely remove and replace the rearends?
>  
> Thanks
>  
> Steve Harvey
> Milwaukee