Rick,
When you install the intake and carbs here is the way that seems to work
best. Install the manifold first. With the manifold alone you can actually
get to the bottom nuts. Then install the heat shield, then the carbs. The
bottom carb bolts are a bit tight but not too bad. You would be amazed at how
badly folks will mangle a heat shield trying to get to the bottom manifold
nuts.
keith
Keith & all
Thanks for the good advice, sounds like a bit of a juggling act with the
exhaust manifold / header. Will leave off the intake & carbs as an assembly
but have he starter on as well as the water pump.
Thanks again
Regards
Rick G
|