OK,
I've managed to break off a wheel stud by dropping the jack a little too fast
to set my new springs, Duh!!
A new wheel stud of the 7/16"-20 variety is not hard to find, but I can't find
one at any of the local parts stores that have the "fine" knurling of the
original stud, just these coarse ones. I hate to pound in a different knurl
pattern just to make it fit. It's kind of like forcing a fine and coarse
threaded nut and bolt to fit. Just doesn't seem right. Any direct replacement
for these original wheel studs?
As always, thanks in advance,
Mike Hudson '67 - 1600
|