datsun-roadsters
[Top] [All Lists]

Re: [Roadsters] Wiper mounting question

To: <datsun-roadsters@autox.team.net>
Subject: Re: [Roadsters] Wiper mounting question
From: "Gary and Cindy Ault" <aultgc@att.net>
Date: Sun, 13 Apr 2008 19:57:54 -0500
Peter,

If the rubber mounts/oval inserts on your wiper motor bracket are 
undisturbed, there should be impressions on the bolt-head side where flat 
washers were located.  If undisturbed, just put it back together so the flat 
washers are in the same positions as they were before you took everything 
apart.  If not, then you will need to play around a bit.  Even if you took 
things apart, you should be able to tell which direction each rubber grommet 
was installed, because they will have taken a "set" over time.  I have two 
spare low-windshield wiper motors.  (Don't ask me how that happened.)  On 
both, the ovals on the portion of the motor bracket closest to the motor are 
transverse to the slots; on the "L"-shaped portion of the motor bracket, 
they are parallel.

What I remember is, on an early car, both pieces of the wiper linkage 
attaches to the eccentric arm on the motor.  I think on  the later cars, the 
shorter arm attaches to the long arm, but I am not sure.  In any event, 
you're trying to align three points in space:  The shaft on the eccentric 
arm, the left wiper pivot and the right wiper pivot.  I think that, if you 
try to assemble it all, there is only one position where the eccentric arm 
and both pivot arms align.

Try putting it together before you put everything else in. if you can.  At 
any rate, when you assemble it all, hook it up and put power to it with the 
bolts just hand-tight, so they can move a bit if they need to.  Then the 
assembly should align itself without damaging anything.

Call if you want.

Anyone else on the List got a better idea?

Gary
(219) 322-1923 -- Central Time

----- Original Message ----- 
From: "peter harrison" <granvillecomputing@hotmail.com>
To: "Gary and Cindy Ault" <aultgc@att.net>
Sent: Sunday, April 13, 2008 6:37 PM
Subject: RE: [Roadsters] Wiper mounting question



Gary

but how does one figure what makes 'sense' ?? :)

Peter 
________________________________________
Support Team.Net  http://www.team.net/donate.html


Datsun-roadsters mailing list

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/datsun-roadsters

<Prev in Thread] Current Thread [Next in Thread>