Neil,
They're a standard hardware item. The Nissan Parts Manual doesn't list the
size, but I'm guessing they're 1/4-28 hex head machine screws. If you don't
have any you can check, let me know and I'll try to find my brake part
spares and check one for you.
I don't think the torque on these is particularly critical -- the threads
are in carbon steel, so it's not like you'll strip them out unless you
really lay into them.. These bolts should have split lock washers on them.
Once you've compressed the lock washer, you're done. Another little bit
doesn't hurt, but it is not necessary to do much more than flatten the lock
washer.
Gary
----- Original Message -----
From: "Neil Levine" <nalevine@dcn.org>
To: <datsun-roadsters@autox.team.net>
Sent: Monday, November 25, 2013 12:09 AM
Subject: [Roadsters] Looking for brake bolts
> I'm doing some work on my front brakes and am looking for a source for the
> cylinder to caliper mounting bolts (4 per cylinder). Does anyone out
> there
> know where I can get them? I have looked on several vendor sites but
> didn't
> have any luck finding them.
>
> Also can anyone tell me the proper torque for these?
>
> Thanks for your help.
>
> Neil
>
> '66 1600
> ________________________________________
>
> datsun-roadsters@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/datsun-roadsters/aultgc@att.net
________________________________________
datsun-roadsters@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/datsun-roadsters/mharc@autox.team.net
|