You are most likely short on petal free play. You either have the later
adjustable push rod or you can add spacers between the master and the
firewall. If the Master is not allowed to fully release the port to the
reservoir
is not uncovered and pressure will build in the system as it warms up.
keith
In a message dated 6/16/2014 7:26:10 P.M. Pacific Daylight Time,
gcmiller56@gmail.com writes:
Finally got my 67 1600 on the road after a bit over a 2 year build. I am
using
a single master cyl system. When I apply and release the brakes the front
calipers still continue to grip. After driving a mile or so the brakes
seize
full on. I cracked the bleed screw on the master cyl. and they release.
There's probably a simply solution, at this point I don't see it. Any
thoughts?
________________________________________
datsun-roadsters@autox.team.net
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/datsun-roadsters/keith0alan@aol.com
________________________________________
datsun-roadsters@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/datsun-roadsters/mharc@autox.team.net
|