The steel plate flywheel I bought didn't need any modifications, and
I'll bet it's nearly as light as an alloy one and a lot stronger.
> -----Original Message-----
> From: Patrick McMullen [SMTP:pmcmull@ibm.net]
> Sent: Wednesday, February 11, 1998 8:54 PM
> To: vinttr4@FORBIN.COM
> Cc: fot@autox.team.net
> Subject: Re: Flywheels
>
> That's what happened to me Jack,
>
> I actually made a longer pushrod to compensate for this. That was
> very
> short lived...as the engine warmed up I could hardly disengage the
> clutch. Not enough throw at that angle. Thats when I went to a
> friend
> of mine with the original throwout bearing holder and asked if he
> could
> make me a new one .500" longer. All is fine now. I'm including a
> .jpg
> attachment of the one I had made along side the original. Not to bad!
>
> Pat in NC << File: adapt.jpg >>
|