| To: | jrhill1@FACSTAFF.WISC.EDU |
|---|---|
| Subject: | Re: TR6 Wheel Offset |
| From: | Mark Bradakis <mjb@cs.utah.edu> |
| Date: | Wed, 25 Feb 1998 15:18:01 -0700 (MST) |
You should be just fine with 3.75 to 4.0 inches of backspace on big TR wheels. Some alloy wheels with a 4" backspace may tend to rub on the ends of the front upper control arms, but a bit of filing will fix it, it isn't much. Well, if your bushings are toast, then you may need more than a bit of filing as the hub flops around to various degrees. mjb. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | TR6 Wheel Offset, Jim Hill |
|---|---|
| Next by Date: | Re: TR6 Wheel Offset, Bob Lang |
| Previous by Thread: | TR6 Wheel Offset, Jim Hill |
| Next by Thread: | Re: TR6 Wheel Offset, Bob Lang |
| Indexes: | [Date] [Thread] [Top] [All Lists] |