| To: | "FOT" <fot@autox.team.net> |
|---|---|
| Subject: | TR4 Sleeve to Block Fit |
| From: | "Peter Vucinic" <vucinic@b140.aone.net.au> |
| Date: | Wed, 26 Feb 2003 13:15:57 +1100 |
Does anyone have the relevant dimensions / limits of fit, for the TR4 cylinder liner into the cylinder block? I am assuming that it is either slight clearance or size-for-size? Any help greatly appreciated. Kind Regards Peter Vucinic WORKS-4 TR-4 |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Hoosier Vintage Snowtires, Larry Young |
|---|---|
| Next by Date: | Fw: Virus Advisory 022503, Mordy Dunst/Gasket Works USA, LLC |
| Previous by Thread: | Hoosier Vintage Snowtires, Larry Young |
| Next by Thread: | RE: TR4 Sleeve to Block Fit, Bill Babcock |
| Indexes: | [Date] [Thread] [Top] [All Lists] |