fot
[Top] [All Lists]

Re: Distributor end float

To: "John Kipping" <johnkipping@inet.net.nz>, "team"
Subject: Re: Distributor end float
From: "Robert Dardano" <19to1tr6@attbi.com>
Date: Sun, 11 May 2003 02:27:42 -0400
Thanks John  It is the drive gear I am asking about . Can these gears be
messured  to determine wear or  is  it just done buy an exper. engine
builder  that  looks them over and decides if  they are good  or bad  Are
drawings availabe to  check how much wear  there is. Are  there specific
tools used to check the pitch of the gear?    thanks    rob
----- Original Message -----
From: "John Kipping" <johnkipping@inet.net.nz>
To: "Robert Dardano" <19to1tr6@attbi.com>; "team" <fot@autox.team.net>
Sent: Sunday, May 11, 2003 1:04 AM
Subject: Re: Distributor end float


> I can't see any reason for distributor end float to be critical, however
it
> is very important for the distributor drive gear to have end float
otherwise
> it can strip teeth of the gear or cam.
> John Kipping
> ----- Original Message -----
> From: "Robert Dardano" <19to1tr6@attbi.com>
> To: "team" <fot@autox.team.net>
> Sent: Sunday, May 11, 2003 3:29 PM
> Subject: Distributor end float
>
>
> > Hi guys and Gals  can anyone explain why distributor end float is
critcal.
> and
> > what may happen when its not adjusted correctly   thanks     rob

<Prev in Thread] Current Thread [Next in Thread>